Heuser® Water Bath WB 6-50

The water quench is an alternative to classic mud treatment equipment and is used exclusively in medical facilities and facilities of physical therapy.

The water quench is a stainless steel container with a heating mat. The water is introduced into the container and heated to about 60 ° C. within 2 hours. Then you should then insert the reusable heat transfer medium with bog filling. The heat transfer media require approx. 45 minutes until they have reached their operating temperature. After warming, you can use the Moor heat transfer medium for the treatment of mud.
Type of water quench Type WB 6-50:
The water quench has an LED display with which the temperature for heating can be precisely adjusted. Due to the supplied tabs, which can be plugged into the injector, up to 8 heat carriers (size: 30×40 cm) can be placed in the water bath. The brackets are also ideal for storing the double heaters in the water bath.

Equipment:

– Self-supporting outer housing made of pattern-rolled stainless steel
– Cover with handlebar and gas pressure spring
– Energy-saving insulation against heat losses
– Temperature detection directly in the water
– With silicone heating mat for optimum heating
– Electronic temperature control between 30 ° C and 85 ° C
– Service indicator light, heating control lamp
– Chromed 1/2 “ball valve for water drainage
– Hose connection on the front side
– Removable inset base / stainless steel insert
– Includes 3 tabs for insertion into the ejector

The training room in physiotherapy can be designed in various ways. Among the established appliances, such as hot air faucets or catcher, there is the alternative of using a water bath.

The water bath can boast a positive energy balance as opposed to the catcher and the warming cabinet. The handling of moor packs and heat loads is somewhat simplified and economical. In addition, the use also results in a time saving for you and your employees.
Technical specifications:

– Capacity 8 heat carriers 30×40 cm
– Internal volume 50 l
– power 1500 W, operating voltage 230 V, 50 Hz
– Internal dimensions WxHxD: 59x20x40 cm
– Outside dimensions WxHxD: 67,5×38,5×47 cm

Suitable for the Fango-treatment unit, which can be used as a table-top unit, there are also mobile sub-bases. With this support the device can be moved very well. We offer further water drainage accessories with the water drain hose.

– For 8 Heat Carrier 30×40 cm
– Inclusive 3 strap to set up the heat carrier
– Inner-volume 50l
– Power 1500 W, Voltage 230 V, 50 Hz
– Inner size WxHxD: 50x20x30 cm
– Outer size WxHxD: 57x37x40 cm

– Self-supporting frame made of stainless steel
– Cap with grip and 2 hinges energy saving isolation against heat losses
– Thermostatic termperture-regualtion between 30°C and 85 °C
– Measrunig of temperture directly inside the water, steadily and quick